Used in the transfer of water, brine, water-based chemicals, water-based acids, and gelatinous proppant (sand) slurry used at hydraulic fracturing sites

• Iron meeting ASTM standards
• 5 Nitrile Rubber O-rings (part # O439BU)
• 20 steel hex head screws (part # HHBT875X175)
• 20 2-1/4" OD hammer union flat washers (part # HUWAS225OD)

6" male NPT manifold with 2" female NPT ports (5-side and 1-end) and a 1" auxiliary port (base plate slotted bolt hole pattern accommodates both Weir SPM and Gardner-Denver FE pumps)

• Manifold designed for efficient fluid flows and reduction of pump cavitation caused by sand fallout
• Single cast unit eliminates welds: a primary cause for premature leakage/failure
• Side ports designed for easy pump cylinder inspection
• Reduced height for ease of installation
• Email [email protected] or visit dixonvalve.com/bosslps for additional information and configurations.