Dy-Mark Mine Marking is a marking out paint specially formulated for above/below ground areas

Horizontal spray design is also available

Vertical Yellow, 350G

• Formulated for above/below ground areas
• 360° valve for any direction spray
• Two nozzle options for upright/inverted spray or horizontal spray application
• Bright, highly visible marks on dark surfaces
• Vertical spray is suitable for use with Dixon's Mine Marking Paint Stick (5m extension)

• Dy-Mark Mine Marking is a marking out paint specially formulated for above/below ground areas (not recommended for underground coal mines - use Mine Marking Non-Flammable). 
• Horizontal features a standard paint nozzle, where the main application is side walls. Vertical is designed for marking ceilings and floors. For high ceilings and hard-to-reach areas, use the Mine Marking height extension handle (suitable for use with both options). Applications include marking out ore zones in grading control, pit walls and sever grids layouts.

• Hold the can upright or in the inverted position and spray with the nozzle approximately 20-25cm from the surface.
• Adjust the spray width by moving closer or further away from the surface to be sprayed.
• Drying Time - 3 minutes (25°C)

• Store correctly- locked up, protected from sunlight, in a well-ventilated place.
• Do not expose to temperatures exceeding 50°C (122°F). 
• Dispose of contents/empty aerosol container according to regional regulations.
  • Spray unwanted paint onto a newspaper, allow to dry and dispose of via domestic waste collection.
  • Empty aerosol cans are recyclable via steel can recycling programs.

Will produce 200+ ‘X’ marks, up to 120 linear metres (depending on surface and colour used)