Imagen
DF-Series Pneumatic Female Threaded Plug
Imagen
F-Series Pneumatic Manual Male Threaded Coupler

PND-DQCKIT6 - Set de Acoplamiento Rápido Serie DF Industrial - Empaque Retail

¿Tienes una duda? 

Llámanos al +8183545649 o da clic en el botón de contacto para mandarnos un email.

Atributos

Peso
2.05 lb
Break Quantity
6
Mandatory Package/Box Quantity
6
Material
Acople - Latón
Tapón - Acero
DE Máximo
Rosca
NPTF
Tamaño de Cuerpo
Rango de Temperatura
6" grooved manifold with six 2" female NT ports, one 1" NPT port (left or right version)°F (Not pressure retaining, open flow only°C)
Medida de Rosca
Longitud
Hex
Acople - 3/4"
Valor de Presión
See Product Details

Detalles

Compatibilidad e Intercambio de Datos

  • Foster 3, 4, 5 and 6 Series
  • Parker 30 - Series Automatic Interchange & Parker 20-Series Manual Interchange
  • Hansen 3000, 4000, 5000 and 6000 & Hansen 1000, 400 and 500

Construcción

  • Machined components are manufactured using solid bar stock.
  • Stainless steel balls, retaining rings and springs maximize corrosion resistance and extend service life.
  • Nitrile (Nitrile Rubber) seals are standard
  • Steel componentry is plated using ROHS Compliant Trivalent Chrome.
  • Steel sleeve and steel tubular valve

Descripción

(Se requieren 6 cajas por caja)

Como funciona

  • To disconnect, begin by holding the hose on the nipple side with three of your fingers, leaving your thumb and index finger free.
  • Grab the sleeve with your thumb and index finger and begin to pull the sleeve towards the palm of your hand.
  • After pulling the sleeve, the nipple will move out of the coupler slightly. Continue to hold the hose and coupler sleeve until all air is fully exhausted.
  • After the line is fully exhausted, you are able to safely separate the nipple from the coupler.

Incluye

2FM2-B, D2F2

Notas de Seguridad

It is important to be safe when installing quick disconnect couplings into a pneumatic circuit. Never install a pneumatic coupling directly into an air tool, use a piece of hose that is at least 18" long, between the tool and the coupling, to prevent damage to the coupling. To protect the operator, safety devices, such as a safety check valve and safety cable should be installed in case there is a hose or coupling failure.

Especificaciones

  • Rated pressure for connected Brass Coupler & Brass Plug: 300 PSI (20 bar) Maximum Working and 8,500 PSI (586 bar) Burst
  • Rated pressure for connected Brass Coupler & Steel Plug: 500 PSI (35 bar) Maximum Working and 9,000 PSI (620 bar) Burst
  • Rated pressure when connected with Steel F-Series Manual Couplers: 500 PSI (35 bar) Maximum Working and 6,500 PSI (448 bar) Burst
  • Rated pressure when connected with Brass F-Series Manual Couplers: 500 PSI (35 bar) Maximum Working and 9,000 PSI (620 bar) Burst