F-Series Pneumatic Manual Female Threaded Coupler

Attributes

Weight	0.56 lb
Break Quantity	1
Optional Package/Box Quantity	1
Material	Steel
Maximum OD	1.24" (31.4 mm)
Thread	NPTF
Body Size	1/2"
Temperature Range	-40°F to 250°F (-40°C to 121°C)
Thread Size	3/4"
Length	3.15" (79.9 mm)
Hex	1-3/16"
Pressure Rating	See Product Details

Details

Compatibility & Interchange Data

Foster 3, 4, 5 and 6 Series
Parker 20-Series Manual Interchange
Hansen 1000, 400 and 500

Construction

Machined components are manufactured using solid bar stock.
Stainless steel balls, retaining rings and springs maximize corrosion resistance and extend service life.
Nitrile (Nitrile Rubber) seals are standard
Steel componentry is plated using ROHS Compliant Trivalent Chrome.
Steel sleeve and steel tubular valve

How It Works

To disconnect, begin by holding the hose on the nipple side with three of your fingers, leaving your thumb and index finger free.
Grab the sleeve with your thumb and index finger and begin to pull the sleeve towards the palm of your hand.
After pulling the sleeve, the nipple will move out of the coupler slightly. Continue to hold the hose and coupler sleeve until all air is fully exhausted.
After the line is fully exhausted, you are able to safely separate the nipple from the coupler.

Safety Notes

It is important to be safe when installing quick disconnect couplings into a pneumatic circuit. Never install a pneumatic coupling directly into an air tool, use a piece of hose that is at least 18" long, between the tool and the coupling, to prevent damage to the coupling. To protect the operator, safety devices, such as a safety check valve and safety cable should be installed in case there is a hose or coupling failure.

Specifications

Rated pressure for connected Steel Coupler & Steel Plug: 500 PSI (35 bar) Maximum Working and 15,500 PSI (1,070 bar) Burst

Use

Can be used with DQC J-series Automotive plugs

Resources

Catalog Page

DSC2023 Page - 395.pdf

4FF6 - F-Series Pneumatic Manual Female Threaded Coupler