Imagen
Learning Video
1/4"
MX | es
Imagen
Imagen
D2K3 - Serie - DF Niple Intercambio Industrial (Conexión Reutilizable para Manguera)
¿Tienes una duda?
Llámanos al +8183545649 o da clic en el botón de contacto para mandarnos un email.
Atributos
| Peso |
0.15 lb
|
|---|---|
| Compra Minima |
1
|
| Paquete Opcional/Cantidad por Caja |
1
|
| Material |
Acero
|
| DE Máximo |
0.81" (20.6 mm)
|
| Seal |
Nitrilo
|
| Tamaño de Cuerpo |
|
| Longitud |
2.16" (54.9 mm)
|
| DI de Manguera |
3/8"
|
| Hex |
9/16"
|
| Flujo |
DELTA P=15 PSI 27 CFM
|
| DE de Manguera |
11/16"
|
| Valor de Presión |
Detalles
Compatibility & Interchange Data
- Foster 3, 4, 5 and 6 Series
- Parker 30 - Series Automatic Interchange & Parker 20-Series Manual Interchange
- Hansen 3000, 4000, 5000 and 6000 & Hansen 1000, 400 and 500
Construction
- Machined components are manufactured using solid bar stock.
- Steel componentry is plated using ROHS Compliant Trivalent Chrome.
How It Works
- To disconnect, begin by holding the hose on the nipple side with three of your fingers, leaving your thumb and index finger free.
- Grab the sleeve with your thumb and index finger and begin to pull the sleeve towards the palm of your hand.
- After pulling the sleeve, the nipple will move out of the coupler slightly. Continue to hold the hose and coupler sleeve until all air is fully exhausted.
- After the line is fully exhausted, you are able to safely separate the nipple from the coupler.
Safety Notes
- It is important to be safe when installing quick disconnect couplings into a pneumatic circuit. Never install a pneumatic coupling directly into an air tool, use a piece of hose that is at least 18" long, between the tool and the coupling, to prevent damage to the coupling. To protect the operator, safety devices, such as a safety check valve and safety cable should be installed in case there is a hose or coupling failure.
- Operating pressure for couplings utilizing hose barb connections may be dramatically reduced to that of the hose rating and/or hose end connection combination. Consult hose manufacturer's catalog for hose end connection ratings. If in doubt, test under controlled conditions for suitability to application.
- Dixon cannot assume liability for misapplication of production resulting in equipment down-time, lost production, and/or personal injury including death.
Specifications
- Rated pressure when connected with Brass D-Series Automatic Couplers: 500 PSI (35 bar) Maximum Working and 16,000 PSI (1,100 bar) Burst
- Rated pressure when connected with Brass F-Series Manual Couplers: 500 PSI (35 bar) Maximum Working and 11,500 PSI (790 bar) Burst
- Rated pressure when connected with Steel F-Series Manual Couplers: 500 PSI (35 bar) Maximum Working and 6,500 PSI (448 bar) Burst
Recursos
Imagen
Learning Video
Dixon Quick Coupling
Catalog Page
Catalog Page 401
Imagen
Learning Video
